• 9849-xxx-xxx
  • noreply@example.com
  • Tyagal, Patan, Lalitpur

BUILD YOUR own DUMB USB POWER strip

Here’s a USB charging center which [Kenneth Finnegan] built using parts from his junk bin. We’d like to reiterate our claim that he should have the most magical of junk bins (the last thing we saw him pull out of it was a 24-port managed Ethernet switch).

The jack on the side accepts the barrel connector from a 12V wall wart. [Kenneth] mentions that the 2.1mm jack is a conventional he uses in all of his projects. inside there’s a switch mode power supply that offers the regulated 5V to each USB port. We really like the fact that he added some protection; diy is no fun if you end up frying your beloved multi-hundred dollar devices. The yellow components are polyfuses which will cut the power if 600 mA of current is exceeded. This works terrific for practically all of his devices, but his iPod 4G doesn’t like the system. It sees the voltage dip just a bit and stops charging entirely.

Leave a Reply

Your email address will not be published. Required fields are marked *